Switchmodule RC-SM-2H

The RC circuit module RC-SM-2H has two outputs that can be switched via a proportional channel on an RC remote control.

The RC SM-2H is connected via a power cable directly to an output of the receiver or via a Y-cable to connect to an existing servo or speed controller.

Various additional sounds can for example be triggered in our sound modules via the two outputs. However, many other applications are conceivable in which any consumer to be switched (eg, lamps, LEDs, small motors, relays, etc.) By using PhotoMOS relays at the two outputs, the outputs are potential-free and, by appropriate wiring, be run as a plus or a minus switching. The standard version was originally developed for the switching of additional sounds and is therefore only suitable for relatively small currents (max. 0.4 A) designed. However, this version called RC-SM-2H can switch a current of max 4 amps. With 2 with jumpers enable selection of four variants:
Touch Function
Switching function (memory switch)
Turn on change of the proportional signal (directional)
Turn on change of the proportional signal (motion-dependent)

The switching thresholds, and the sensitivity can be adjusted with the change of the proportional signal. The module is supplied with a 30cm long servo cable with Graupner connectors. The connections for the two outputs are designed as solder connections.

Specifications:
Required INT-proportional channel: 1
Supply voltage: 4.8 to 6.0 V (via RC receiver)
Current consumption: approximately 10mA
Switching outputs: 2 piece floating, plus-or minus-switching
Switching voltage: max. 40V DC
Switching current (per output): 4.0 A at RC-SM-2H

Switching variants:
• Switch function • Switching function (memory switch)
• Turn on change of the proportional signal (directional)
• Turn on change of the proportional signal (motion-dependent)
Switching threshold: Adjustable between 1.0-1.5 and 1.5-2.0 ms

Dimensions: 39 x 25 x 13mm
Weight: 11g