DMW wig/wag flasher unit

An receiver controlled wig/wag flasher unit.

On the older units (pre Feb 2020) theouter pins are +ve supply and the inner pins -ve. These work from a receiver and pass the receiver supply (normally 5 volts) through to the leds connected to the pins.

On the new units (post feb 2020) the outer pins are -ve supply and the inner pins +ve. These work from a receiver and pass the receiver supply (normally 5 volts) through to the leds connected to the pins.

The unit has four different flash modes and off.

N.B. You must use resistors to limit the current to the LED's